Yahoo Search Búsqueda en la Web

Entrar

Resultado de búsqueda

  1. www.cisco.com › c › es_mxUso de los comandos Standby Preempt y Standby Track - Cisco

    26 de sept. de 2023 · Este diagrama muestra un ejemplo que utiliza el comando standby preempt junto con el comando standby trackcommand. Standby Preempt y Standby Track Configuration. Ejemplos de Configuración. En el diagrama de red, HSRP está configurado de la siguiente manera: R1 es el router activo y hace el seguimiento del estado de la interfaz serial 0 de R1.

  2. www.cisco.com › configuration › guideConfiguring Active/Standby Failover - Cisco

    Active/Standby failover enables you to use a standby ASA to take over the functionality of a failed unit. When the active unit fails, it changes to the standby state while the standby unit changes to the active state.

  3. www.cisco.com › c › enUse the Standby Preempt and Standby Track Commands - Cisco

    26 de sept. de 2023 · The standby track command allows you to specify another interface on the router for the HSRP process to monitor in order to alter the HSRP priority for a given group.

  4. community.cisco.com › t5 › routingSolved: ASA - Active/standby topology - Cisco Community

    26 de dic. de 2020 · I am trying to set up a basic active/standby topology in GNS3. In all the setups that I'm seeing, there is a L2 switch on each side of the ASAs. I have a core switch and a gateway router between my ASAs.

  5. www.academia.edu › 29219474 › Cómo_utilizar_los_comandos_standby_preempt_y_standby(PDF) Cómo utilizar los comandos standby preempt y standby track...

    Si no usa el comando standby preempt en la configuración de un router, dicho router no se convertirá en el router activo, incluso aunque su prioridad sea superior a la de los routers restantes. standby 1 track Serial1 !--!--!--!--!--!--- Indica que HSRP hace un seguimiento de la interfaz Serial1.

  6. community.cisco.com › t5 › routingHow to track default route - Cisco Community

    5 de abr. de 2013 · So you have two default routes - the one with the track command is primary - it has a metric of 1 but is being tracked! The sla and track will ping 8.8.8.8 and if successful it will install this in the routing table.

  7. community.cisco.com › t5 › network-securitySolved: Active/Standby Failover - Cisco Community

    29 de sept. de 2009 · The monitor-interface command is how you keep track of an interface. So you monitor those interfaces that if they fail you want the firewall to failover. You can set a % of failed interfaces that must occur before failing over.